CNC copper processing

UG software programming is used. Copper centimeters are divided into rough and young ones. Two programs are used for construction drawings respectively. When finishing milling, use a knife with a smaller diameter to rough clear the margin of the angle position. Where the angle cannot be cleared

UG software programming is used. Copper centimeters are divided into rough and young ones. Two programs are used for the construction drawing. When finishing milling, use a knife with a smaller diameter to rough the corner allowance. If the corner cannot be cleared, a curved surface must be used to block the corner allowance, so as to avoid tool damage caused by excessive corner allowance during finishing milling. At the same time, ensure that the allowance is uniform during finishing milling. We use advanced precision engraving equipment and tools. The machining accuracy of copper centimeters can reach 0.005-0.01MM, After processing, use three dimensional measurement to check the dimensional accuracy of each copper bar.